R-2 Zone in Richmond, VA
R-2 zoning district rules in Richmond, VA. Permitted uses, setbacks, height limits, and lot coverage requirements.
The R-2 zone in Richmond, VA is a residential district (Two-Family Residential). Permits up to two dwelling units per lot (duplex). Allows slightly higher density than R-1 while maintaining low-density neighborhood character. This zone requires a 25 ft front setback, 6 ft side setback, and 25 ft rear setback. Maximum building height is 35 feet (2 stories). Maximum lot coverage is 40%.
Common Permitted Uses
- Single-family homes
- Duplexes
Permits up to two dwelling units per lot (duplex). Allows slightly higher density than R-1 while maintaining low-density neighborhood character.
Setback Requirements
| Setback Type | Requirement |
|---|---|
| Front Setback | 25 feet |
| Side Setback | 6 feet |
| Rear Setback | 25 feet |
Richmond City Code Chapter 30. R-2 standard single-family residential.
Height Limits
- Max Height
- 35 feet
- Max Stories
- 2
Richmond City Code Chapter 30.
Lot Coverage
- Max Coverage
- 40%
Richmond City Code Chapter 30.
Parking Requirements
Single-family: 2 off-street parking spaces per single-family dwelling. Many older Richmond neighborhoods have limited parking — some lots have reduced requirements. Multi-family: 1–1.5 spaces per unit depending on bedroom count. Reduced requirements near GRTC transit corridors.
Source: Richmond City Code Chapter 30 — Zoning; Virginia Code Section 15.2-2291. Last verified April 6, 2026. View source