Setback Requirements in Richmond, VA (2026)
Front, side, and rear setback requirements by zoning district for Richmond, VA. Source-cited from official municipal code.
Setbacks by Zoning District
| Zone | Front | Side | Rear | Notes |
|---|---|---|---|---|
| R-1 | 30 feet | 8 feet | 30 feet | Richmond City Code Chapter 30. R-1 is the lowest density single-family zone — large lots in older residential neighborhoods. |
| R-2 | 25 feet | 6 feet | 25 feet | Richmond City Code Chapter 30. R-2 standard single-family residential. |
| R-3 | 20 feet | 5 feet | 20 feet | Richmond City Code Chapter 30. R-3 allows duplex in addition to single-family. |
| R-4 | 15 feet | 5 feet | 15 feet | Richmond City Code Chapter 30. R-4 multi-family low density. Common in older Richmond neighborhoods. |
| R-5 | 10 feet | 5 feet | 10 feet | Richmond City Code Chapter 30. R-5 multi-family medium density. Prevalent in Near West End, Museum District. |
All setbacks measured from property line. Verify with Richmond Department of Planning and Development Review before submitting permit applications.
Frequently Asked Questions
Can I build an accessory apartment (ADU) in Richmond?
Yes. Virginia law requires Richmond to allow accessory apartments in single-family residential zones. You can build one accessory apartment per lot — either attached or detached. The unit can be up to 1,000 sqft for detached or 50% of primary dwelling floor area for attached. Owner-occupancy of either unit is required. No significant impact fees apply in Richmond.
Does Richmond allow short-term rentals like Airbnb?
Yes, with a Short-Term Rental Permit ($200/year). Richmond requires that the property be your primary residence. You must comply with Richmond noise ordinance and occupancy limits, and Virginia's 7% Transient Occupancy Tax applies. STR platforms collect and remit this tax automatically.
What permits are required for renovation in Richmond?
Most structural, electrical, plumbing, HVAC, and addition projects require building permits from Richmond's Department of Planning and Development Review. Properties in Richmond's 18 historic districts have additional requirements — the Historic Preservation Office reviews exterior changes to contributing structures. Richmond's online permit portal streamlines applications.
How does Richmond's independent city status affect zoning?
Richmond is an independent city — it is not part of any county. All zoning and building permits are administered exclusively by Richmond's city government, not any county. This is unusual in most US states but common in Virginia, which has 38 independent cities. There is no county building department or county zoning board — everything goes through Richmond's own DPR.
Are there solar restrictions in historic Richmond neighborhoods?
Yes, in designated historic districts. Richmond's Historic Preservation Office reviews solar panel installations visible from public streets in HPO-regulated districts like The Fan, Church Hill, and Jackson Ward. Panels on rear or non-street-facing slopes are generally approved without HPO review. Virginia's Solar Freedom Act prevents HOAs from prohibiting solar panels entirely.
What are Richmond's flood zone areas?
Richmond has notable flood risk along the James River and Shockoe Bottom areas. Shockoe Bottom and portions of the riverfront are in FEMA-designated Special Flood Hazard Areas. If your property is in a flood zone, Richmond requires elevation certificates and may require floodproofing for new construction. Check FEMA's Flood Map Service Center or Richmond's GIS portal for your property's flood zone designation.
Source: Richmond Zoning Code — Setback Requirements. Last verified April 6, 2026. View source